Installation Instructions - Page 2 of 3 - SanseAuto


  1. You need to fix up the ballast at the ventilating place so that it can scatter heat easily. Forbid to install the ballast besides at the engine or fan when you are remodify HID lamp .If the temperature of ballast achieve to 105 degree,it will cut off the power by itself.
  2. Please mention to install the earthling wire, if the earthling wire isn’t good, the xenon lamp will appear flicker.
  3. Avoid scratching the bulbs during the installment; don’t touch the bulbs’ vitreous body.
  4. Please check correct of the linker, ends, leads, or it will fail due to the improper installment.
  5. When adjust the bulbs, the bulbs’ end can’t meet with lamps assembly.
  6. Please get the power souse from the voltage bottle, until confirm the correct installment; you can connect with voltage bottle.
  7. Don’t remove and remodify in personal, we will not charge any resibonsibility.
  8. Please ask special department near you for help when you need to replace and repair your goods.
  9. During installment, if you have not enough time for install the bulbs, it will cause the bulbs or ceramic pipe broken. Please unlade the lamps assembly and install them again.

Products Installment Kits

  • Ballaststwo pieces
  • HID xenon lamptwo pieces
  • Screwone bag
  • Nylon line bundleone bundle
  • Adapter wiringone group
  • Ballast bracketstwo pieces

Call Us (604) 771 0112

#4 - 12191 Bridgeport RD

Richmond BC

V6V 1J4